GMW15559

Description / Abstract: GMW15559, 3rd Edition, April 2018 - Bend Test for Heat Treated Parts Made from Flat Rolled or Wire Steel Products

Introduction

Note: Nothing in this standard supercedes applicable laws and regulations.

Note: In the event of conflict between the English and domestic language, the English language shall take precedence.

Purpose.

This standard describes the procedures to be used in determining the bend test ductility of heat treated parts or heat treated and plated parts made from flat, hot or cold rolled steel or round steel rod or wire products. Parts capable of being bent to the print specified minimum angle without fracture per this procedure are considered to have adequate bend ductility for the heat treated or heat treated and plated condition specified.

Applicability.

The bend test ductility of heat treated parts is to be measured from flat, hot or cold rolled steel or round steel rod or wire products.