Full Description

1.1This test method covers the measurement of dynamic viscosity and derivation of kinematic viscosity of liquids, such as new and in-service lubricating oils, by means of an oscillating piston viscometer.

1.2This test method is applicable to Newtonian and non-Newtonian liquids; however the precision statement was developed using Newtonian liquids.

1.3The range of dynamic viscosity covered by this test method is from 0.2mPas to 20000mPas (which is approximately the kinematic viscosity range of 0.2mm/s to 22000mm/s for new oils) in the temperature range between -40C to 190C; however the precision has been determined only for new and used oils in the range of 34mPas to 1150mPas at 40C, 5.7mPas to 131mPas at 100C, and 46.5mm/s to 436mm/s at 40C.

1.4The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.